Have you ever wondered whether beauty can be strong too?
Stones are chosen to be installed at any surface altogether for their beauty and strength. They have a rich color with an exquisite crystalline structure and strength to be relied on. And if cared for the last longer than ever. But that care might be a typical task sometimes especially in the busy lives of today.
But what if we say that we have a product that can give your stones a richer color, a more natural texture, and would also leave them resistant to stains. That sounds almost impossible, Right?
No, it’s not when Shrinath Chemicals is dedicatedly working to make your lives easier!
The ‘Stain Repellent Range’ of Shrinath Chemicals presents you ‘Wet-Look Sealer’ that visually improves the appearance of stone also leaving them resistant to stains. It also protects your stones from weathering and thus increases their life.
What is Wet Look Sealer?
Wet Look Sealer is a product of the Stain Repellent Range of Shrinath Chemicals. As the name suggests, the product on the application leaves the stone surface with a richer wet look even without wetting it.
It is based on advanced Nanotechnology that penetrates the surface as well as forms an invisible layer on the stone surface. This layer that stays on the surface is responsible for its richer color and texture. And the layer that penetrates the surface is responsible for its stain and weathering resistant properties.
But wait, Wet Look Sealer gives you more than just a richer color and stain resistance. Wondering what all?
- Enhanced color
- More natural touch
- Matt or Gloss effect as per your desire
- Water repellence. So that you don’t have to worry about damage due to efflorescence
- Oil repellence. Hence no oil staining
- Dirt repellence. Hence the surface becomes easy to clean
- Stain repellence. No tension of staining due to accidental spillage
- UV resistance. Thus, can be used for indoors and outdoors
- No stick layer visible. So that none of your guests would know the secret of beautiful stones.
- Breathable surface. This means no damage due to the accumulation of water vapours inside the surface.
- Less consumption of the product.
- Easy and quick to apply
- Low VOC
- Environment-friendly. No damage to the environment.
- And many more…
Wet-Look Sealer can be used for a wide range of stones, including:
- All kinds of dense natural stones like granite, sandstone, slate, etc.
- All kinds of porous natural stones like marble, limestone, etc.
- Can also be used on Coated Metal. (Tin-shades)
It’s potential application areas include:
- Floors
- Table tops
- Kitchen countertops
- Facades
- Terrace, etc.
Wet Look Sealer even being a multipurpose product, is easy and quick to apply. Just follow the steps:
Firstly, clean the surface thoroughly. It should be free from any dirt, grease, oil, fungus, algae, mildew, efflorescence, etc. you may use our ‘Algae N Moss Remover’ for cleaning the surface.
Nextly, apply Wet Look Sealer on the surface using a roller, brush, or sprayer. Once you have applied it, wait for 15 min and remove extra if the surface is porous. Wait for 45min if the substrate is dense and then remove excess.
For a matt finish, apply two to three coats and remove excess from each coat including the final coat.
For a glossy finish, apply two to three coats and remove excess from each coat except the final coat.
Lastly, let the surface dry for 24 to 48 hours. And the surface is ready to use.
Wondering how does it look like?
It is a transparent liquid that gives a glossy or matt look to the surface depending upon the application.
